Rubber Coating Aerosol Spray

Rubber In a Can

Rubber in a Can is easy to use right from an aerosol can. This product comes out of the can as a black rubberized liquid. Rubber In a Can from Alvin Products flows into cracks and holes and creates a tight rubber surface drying to a flexible, rubberized watertight coating. Alvin’s rubber in a can should be in every garage, tool box and on the job site.

  • Stays flexible
  • Seals water and moisture penetration
  • Non sagging formulation
  • Will not crack, chip or peel
  • Application to wet and dry surfaces
  • Paintable

Used on Pipes, Gutters, drip pans, roofs, down spouts, campers and RV’s, skylights, leaky surfaces, duct work and a/c units, boats, outdoor fountains, birdbaths, ponds and planters, concrete foundations or any surface you need a water tight rubber sealant.

Alvin Products recommends testing each application for suitability.

Shake well! Spray on a clean surface holding can 12-15 inches from the surface and apply using steady even strokes. Apply multiple thin coats instead of a single thick coat to ensure dry time and adhesion.

Buy Online Now

PTEN Top 100

Product Applications

Rubberized Coating
Rubberized Coating
Fix Roof Leak
Fix Roof Leak
Rubber IN a Can Logo
Rubber IN a Can Logo
Motor Home Leak Sealant
Motor Home Leak Sealant

ALVIN PRODUCTS ~ A DIVISION OF DAMPNEY COMPANY, INC.
85 PARIS STREET ~ EVERETT, MA 02149
Phone (978) 423-7681 ~ Fax (617) 389-0484
COPYRIGHT© 2001 - 2011. ALL RIGHTS RESERVED.

www.alvinproducts.com