Rubber Coating Aerosol Spray

Rubber In a Can

Rubber in a Can is easy to use right from an aerosol can. This product comes out of the can as a black rubberized liquid. Rubber In a Can from Alvin Products flows into cracks and holes and creates a tight rubber surface drying to a flexible, rubberized watertight coating. Alvin’s rubber in a can should be in every garage, tool box and on the job site.

  • Stays flexible
  • Seals water and moisture penetration
  • Non sagging formulation
  • Will not crack, chip or peel
  • Application to wet and dry surfaces
  • Paintable

Used on Pipes, Gutters, drip pans, roofs, down spouts, campers and RV’s, skylights, leaky surfaces, duct work and a/c units, boats, outdoor fountains, birdbaths, ponds and planters, concrete foundations or any surface you need a water tight rubber sealant.

Alvin Products recommends testing each application for suitability.

Shake well! Spray on a clean surface holding can 12-15 inches from the surface and apply using steady even strokes. Apply multiple thin coats instead of a single thick coat to ensure dry time and adhesion.

Buy Online Now

PTEN Top 100

Product Applications

Roof Flashing Repair
Roof Flashing Repair
Rubberized Sealant Auto Body
Rubberized Sealant Auto Body
Truck Bed Rubberized Coating
Truck Bed Rubberized Coating
Foundation Crack Seal
Foundation Crack Seal

ALVIN PRODUCTS ~ A DIVISION OF DAMPNEY COMPANY, INC.
85 PARIS STREET ~ EVERETT, MA 02149
Phone (978) 423-7681 ~ Fax (617) 389-0484
COPYRIGHT© 2001 - 2011. ALL RIGHTS RESERVED.

www.alvinproducts.com